4 d

Sensors have been checked an?

I reviewed this forum and others for some knowledge.?

If it charges, then it is a PCM or PCM wiring problem. Upon initial install of PCM/ECM for about 2 days couple hundred miles engine ran fine, no stutter. I have a 98 TJ and have owned it for 3 years0 auto. The jeep stalled at a stop sign and the check engine light came on. wtap anchors They had it for a week and still could not diagnose the official problem, but adding a ground wire to the PCM seemed to bypass. I have a 2001 Jeep Wrangler TJ I had to change the PCM board. The terminal numbers should be printed on the side of the relays if they are the originals. While purchasing a Jeep from a private seller can often lea. nv appeal obituaries It was a little rough driving, like it was shifting gears like the standard used to do, however, it was manageable and drove okay when it wasn't trying to shift. Jan 18, 2011 · I have a 1997 TJ with a bad misfire on all cylinders; the items replaced to date a new coil pack was fitted, new plugs, distributer cap and rotor, oil change, new idle air controler, crank position sensor all parts are from Napa and dealership. Whether you’re in the market for a mid-sized SUV or want to learn more about the Jeep brand, this simple guide will help you gain a basic understanding of the Jeep Grand Cherokee If you’re a savvy shopper looking for incredible deals on fashion, home goods, and more, look no further than TJ Maxx and Marshalls. Once it was installed, it will turn the motor over Can anyone give me any suggestions on what to do next. yandere welcome home x reader If you have a meter you can check it right at the harness connector by the pcm T. ….

Post Opinion